Copying the YAT beacon on 260.5 mhz with an Icom 756 ProIII in CW mode. Signal is very weak, however the morse identifier is audible enough to make out. I am using a multi-band Alpha Delta DXLB dipole. Location here is Milton, Ontario just west of Toronto.
The YAT beacon on 260 KHz was copyable here in Amherst, NYon 24 December 2011 at 0655Z. I received it with a Yaesu FT-450AT amateur radio transceiver and an 8 meter vertical antenna.
YAT comments
Latest comments
YAT reception 260 KHz
🔗 Wed, 27 Nov 2019
— @KM1R at Attawapiskat Airport, Canada Reply
11/26/2019 YAT 260 Kc 0115-0630 EDST 400 Hz offset ID-6 sec tone- ID loud signal, above any local DB. NO co-channel or adjacent channel interference. Minimal atmospherics. steady signal with very little fading. RECEIVER: Collins R390a with homebuilt VLF converter / preselector / bandpass filter. ANTENNA: Marconi "T" antenna 22m vertical, 121m horizontal
would like your postal mailing address to send a written report and pre-made confirmation card.
thanks!
Mike KM1R
Contact info
🔗 Tue, 23 Sep 2014
— @david at Attawapiskat Airport, Canada Reply
Phone: +1-807-473-2082
YAT ND beacon
🔗 Tue, 10 Jan 2012
— Anonymous Flyer at Attawapiskat Airport, Canada Reply
Copying the YAT beacon on 260.5 mhz with an Icom 756 ProIII in CW mode. Signal is very weak, however the morse identifier is audible enough to make out. I am using a multi-band Alpha Delta DXLB dipole. Location here is Milton, Ontario just west of Toronto.
Copied the YAT NDB
🔗 Sat, 24 Dec 2011
— Anonymous Flyer at Attawapiskat Airport, Canada Reply
The YAT beacon on 260 KHz was copyable here in Amherst, NYon 24 December 2011 at 0655Z. I received it with a Yaesu FT-450AT amateur radio transceiver and an 8 meter vertical antenna.
Wm Keith Hibbert, WB2VUO
email: wb2vuo@arrl.net